LED display technical parameters

1. Indoor screen series 
　　Indoor screen area is generally less than a dozen square meters, point density is higher, in the non-direct sunlight or lighting environment, viewing distance in a few meters away, the screen does not have the ability to seal waterproof. Depending on the control mode and the display color, it can be divided into the following:
Indoor full-color video screen
★ the use of independent research and development of point-by-point correction technology, to ensure that the point and point uniform consistency.
★ the light-emitting points of the display panel are tested with a column-shaped light-emitting diode,
　 The vertical horizontal full view can reach 150 degrees.
★ the reflective housing that forms the lamp board is made of open mold and seamlessly matches the luminescence point, and the finished product can be 
　 The surface height error is minimal.
★ the use of light-emitting diodes, the light-emitting brightness is 6-8 times the brightness of the light-emitting wafer.
★ the heat of the light-emitting diode is mainly dissipated from the metal pin, which determines the display panel
　 Good thermal performance.
★ bad light-emitting diodes can be replaced one by one, without affecting the use of other light-emitting tubes.
　 Reduce maintenance costs.
★ the use of the latest technology of video control system, the display color bright and clear. 
★ main technical parameters
Base RGB (Full Color) Pixel Diameter (mm) 5.00 8.00 
Pixel Pitch (mm) 7.62 10.00
Pixels make up 1R1G1B 2R1G1B virtual pixels 
Unit Panel Points (Points) 32 x 32 32 x 16 
Unit panel size (mm) 245 x 245 320 x 160 
Unit panel weight (g) 1100 850 
Physical pixel density (dot/m2) 17200 10000 
Virtual pixel density (dot/m2) 16384 40000 
Peak power consumption (W/m2) 850 750 
Average power consumption (W/m2) 350 320 
Weight (Kg/m2) 36 
Horizontal viewing angle 150 degrees 
Vertical viewing angle 150 degrees 
Maximum brightness (cd/m2) 1700 800 
Indoor dual-base video screen
★ display module uses large factory products, the whole screen brightness and light consistency is good.
★ the system is stable and mature, simple installation requires no commissioning, and the failure rate is extremely low.
★ the use of the latest technology of video control system, the display color bright and clear. 
★ main technical parameters
Base RG (Red, Green Double Base) 

Pixel Diameter (mm) 3.75 5.00 
Pixel Pitch (mm) 4.75 7.62 
Pixels make up 1R1G 1R1G 
Unit panel points 64 x 32 (or 80 x 32) 80 x 32 
Unit panel size (mm) 
　　　　　　　306 x 153 (or 382 x 153) 
　　　　　　　　　　　　　　　　 612x245 
Unit panel weight (g) 800 1500 
Pixel density (dot/m2) 
　　　　　　　　43000 17200 
Peak power consumption (W/m2) 700 350 
Average power consumption (W/m2) 300 200 
Visual angle 150 degrees 
Communication distance (m) 100 (no trunk) 

Indoor monochrome screen
★ display module uses large factory products, the whole screen brightness and light consistency is good.
★ the system is stable and mature, simple installation requires no commissioning, and the failure rate is extremely low.
★ can be synchronized or asynchronous depending on the usage requirements. 
★ main technical parameters
Base monochrome 
Pixel Diameter (mm) 3.0 3.75 5.00 
Pixel Pitch (mm) 4.0 4.75 7.62 
Pixel composition 1R 1R 1R 
Unit Panel Points (Points) 
　　　　　　　 64 x 32 64 x 32 80 x 32 
Unit panel size (mm) 
　　　　　　　　　　　　　 306 x 153 612 x 245 
Unit panel weight (g) 
　　　　　　　　700 900 1500 
Pixel density (dot/m2) 
　　　　　　　 62500 43000 17200 
Peak power consumption (W/m2) 
　　　　　　　 500 350 200 
Average power consumption (W/m2) 
　　　　　　　 350 200 100 
Visual angle 150 degrees 
Communication distance (m) 100 (no trunk) 

2. Half-outdoor screen series 
　　Semi-outdoor screens generally use light-emitting single-light light to form a light-emitting point, suitable for high brightness and waterproof environment, such as: under the eaves, window, strong light hall. Point spacing is generally around 7.62mm-10mm, light-emitting color is generally single red or red/green double base color, control mode according to the use requirements, there are asynchronous, synchronous graphics, video and so on.
★ main technical parameters
Base Monochrome/Double Base 

Pixel Diameter (mm) 5.00 5.00 
Pixel Pitch (mm) 7.62 10.00 
Pixels make up 1R 1R 
Unit Panel Points (Points) 80 x 32 32 x 16 
Unit panel size (mm) 612 x 245 320 x 160 
Unit panel weight (g) 1700 1000 
Pixel density (dot/m2) 17200 10000 
Peak power consumption (W/m2) 400 300 
Average power consumption (W/m2) 250 200 
Horizontal viewing angle 60-70 degrees 
Vertical viewing angle 45-60 degrees 
Maximum brightness (cd/m2) 3000 1800 

3. Outdoor screen series 
　　Outdoor screen area is generally more than ten square meters, high brightness, can be used in direct sunlight environment, viewing distance in general in more than a dozen meters away, the screen has the ability to seal waterproof. Depending on the control mode and the display color, it can be divided into the following:
Outdoor full-color video screen
★ The light points of the display panel are illuminated with solid-color ultra-high-brightness light-emitting diodes, showing 
　 The effect is real and natural.
★ lamp board for the box structure, easy installation, appearance is flat.
★ the use of the latest technology of video control system, the display color bright and clear. 
★ main technical parameters
Base RGB (Full Color) 

Pixel Diameter (mm) 15.00 18.00 
Pixel Pitch (mm) 20 25 
Pixels make up 2R1G1B 2R1G1B 
Unit Panel Points (Points) 
　　　　　　　　　32 x 16 32 x 16 
Unit panel size (mm) 
　　　　　　　　　640 x 320 800 x 400 
Unit panel weight (g) 1500 1000 
Pixel density (dot/m2) 2500 1600 
Peak power consumption (W/m2) 1000 800 
Average power consumption (W/m2) 380 350 
Weight (Kg/m2) 42 to 40 
Horizontal viewing angle 70 degrees 
Vertical viewing angle 45 degrees 
Maximum brightness (cd/m2) 7000 800 
Outdoor dual-based video screen
★ lamp board for the box structure, easy installation, appearance is flat.
★ the use of the latest technology of video control system, the display color bright and clear. 
★ main technical parameters
Base RG (Double Base) 

Pixel Pitch (mm) 
　　　　　　11.5 16.0 22.0 
Pixels make up 2R1G 2R1G 2R4G 
Unit Panel Points (Points) 
　　　　　 32 x 16 32 x 16 32 x 16 
Unit panel size (mm) 
　　　　　 368 x 184 512 x 256 704 x 352 
Unit panel weight (g) 
　　　　　 1000 1500 2300 
Pixel density (dot/m2) 
　　　　　 7600 4096 2048 
Peak power consumption (W/m2) 
　　　　　 800 600 500 
Average power consumption (W/m2) 
　　　　　 300 250 150 
Visual angle 70 degrees 
Communication distance (m) 100 (no trunk)